A useful Laney LC 30 mk2 blog.

I promise this will be useful. Not to Mesa, Fender, Marshall, Valco, Hiwatt, Matchless, users/ owners of course. Nor will it be much good for those needing information on house training a rhinoceros. But there will be a smattering (you didn’t know I knew that one eh?) of almost interesting information.

This (the Laney LC 30 mk2) is a noisy amp to my mind. One reason for this is that the centre tap of the heater supplies is grounded (via a 2amp fuse) to chassis. Another reason is that the pcb is grounded via the pot screws to the front panel metal work.

One thing you really don’t want in an amp is ac currents through the chassis. It introduces noise at every stage. So the best way to ground the heater CT is at a star point at the incoming earth. (At the IEC mans input in other words.) Make only one connection to each section of the chassis and lead these wires back to the same ground star point. The ground to the pots is best hard wired, again to the star point.

Sorting that out will produce a significant improvement. You can’t do much with the heater wiring. AC heater wiring is traditionally twisted together; for good reason. The twisting produces a cancelling effect of the heater current-generated hum. In this amp the wiring is not twisted anywhere in it. This amp, it seems, had an optional pcb, that converts the heater supplies to dc. In that case (if it is done well) the heaters don’t generate hum. But if it’s not a good supply design it will generate 100Hz buzz. Oh well.

The third problem that you may be able to rectify, is the fact that the design omits two control grid leak resistors on the first and third preamp valves. If you connect a 220K resistor from the centre grounded pillar of the first valve to pin 7, and repeat the procedure on the third valve, the noise levels will be attenuated by a lot of db.

I thought this was a sort of responsible blog. But I don’t get a macaroon because I didn’t get a laugh out of it. And there are few things more significant than that.

Comments are closed.